1-20
Cisco 7200 Series Port Adapter Hardware Configuration Guidelines
OL-3875-11
Chapter 1 Cisco 7200 Series Port Adapter Installation Requirements
Bandwidth and Bandwidth Point Requirements
Virtual Private Network
Acceleration Module
13
SA-VAM High on
NPE-225
Not
supported on
NPE-150,
NPE-175,
NPE-200
300 0.26 MB —
Virtual Private Network
Acceleration Module 2
13
SA-VAM2 High on
NPE-225
Not
supported on
NPE-150,
NPE-175,
NPE-200
600 0.26 MB —
Virtual Private Network
Acceleration Module 2+
13
SA-VAM2+ High on
NPE-225
Not
supported on
NPE-150,
NPE-175,
NPE-200
NPE-300
600 0.26 MB —
VPN Service Adapter (VSA) See Acceleration Module, page 1-15.
Token Ring
4-port Token Ring half-duplex PA-4R
11
Medium 60
11
0.30 MB —
4-port Token Ring full-duplex PA-4R-FDX
11
High 120
11
0.30 MB —
4-port dedicated Token Ring PA-4R-DTR 120
Voice
2-, 4-, and 8-port multichannel
T1/E1
PA-MCX-2TE1 Low 0 10 MB —
PA-MCX-4TE1
PA-MCX-8TE1 Low 0 10 MB
PA-MCX-8TE1+
14
Low 0 10 MB —
Single-port low capacity PA-VXA-1TE1-24+ Low 0 2 MB —
PA-VXA-1TE1-30+ Low 0 2 MB —
2-port moderate capacity PA-VXB-2TE1 Low 0 2 MB —
2-port high capacity PA-VXC-2TE1 Low 0 2 MB —
Table 1-6 Bandwidth, Bandwidth Points, and Processor Memory Requirements (continued)
Port Adapter Type Product Number
Bandwidth
Resource
Requirement
Bandwidth
Points
Processor
Memory
Required
1
Additional
Requirements