Cisco 7206VXR - VPN Bundle Router - Default Chapter; Table of Contents

iii
Cisco 7200 Series Port Adapter Hardware Configuration Guidelines
OL-3875-11
CONTENTS
Preface v
Document Revision History v
Introduction v
Other Documentation vi
Obtaining Documentation, Obtaining Support, and Security Guidelines vii
CHAPTER 1 Cisco 7200 Series Port Adapter Installation Requirements 1-1
Chassis Overview—Front View 1-2
Chassis Overview—Rear View 1-3
Configuration Guidelines and Requirements 1-4
PCI Buses and Port Adapter and I/O Controller Architecture 1-4
Port Adapter Slot Numbering 1-5
Guidelines for Installation 1-6
Installation Requirements Based on the NPE or NSE Installed 1-8
NPE-G1 or NPE-G2 Bandwidth Calculation and Configuration Instructions 1-8
Sample Bandwidth Configuration for the NPE-G1 or NPE-G2 1-9
NPE-G1 or NPE-G2 with a Port Adapter Jacket Card—Bandwidth Calculation and Configuration
Instructions
1-9
NPE-400, NPE-300, and NSE-1 Bandwidth Calculation and Configuration Instructions 1-9
Sample Bandwidth Configuration for the NPE-400, NPE-300, and NSE-1 1-10
NPE-225, NPE-200, NPE-175, NPE-150, and NPE-100 Bandwidth Calculation and Configuration
Instructions
1-11
Sample Bandwidth Configuration for the NPE-225, NPE-200, NPE-175, and NPE-150 1-12
Bandwidth and Bandwidth Point Requirements 1-13
Requirements Summary 1-13
Port Adapter Jacket Card 1-13
NPE-G1 or NPE-G2 1-13
NPE-400, NPE-300, NSE-1 1-13
NPE-225, NPE-200, NPE-175, NPE-150 1-14
NPE-100 1-14
Bandwidth Table 1-14
Bandwidth Calculation Table 1-22
Messages for One Port Use of Specific Port Adapters and an I/O Controller 1-22