Figure 22: Cisco 8102-64H Power Supply LED
Status LED1
Table 7: Power Supply LED Descriptions
StatusColorLED
Power supply is on and transmitting power to the router.GreenSTATUS
Power supply is connected to input power source but not transmitting
power to the router.
Flashing Green
Power supply failure, due to one of the following conditions:
• Over voltage
• Over current
• Over Temperature
• Fan failure
Amber
Power supply is operating but a warning condition has occurred, due
to one of the following conditions:
• High temperature
• High power
• Slow fan
Flashing Amber
Power supply units are not receiving power.Off
The operator has activated this LED to identify this PSU.
Flasing BlueAttention
This PSU is not being identified.Off
Hardware Installation Guide for Cisco 8100 Series Routers
40
LEDs
Power Supply LEDs
To Next Page
