7
Installing Memory and Power Over Ethernet in Cisco 880 Series and Cisco 890 Series Integrated Services Routers
OL-16194-01
Installing Power Over Ethernet
Step 4 Install the metal standoffs provided in the accessory kit as shown in Figure 5. Install the two metal
standoff that have two notches into the two star patterned standoff holes. Install the metal standoff that
has one notch into the third standoff hole. Use a 1/4-inch nut driver to tighten the standoff with one notch,
and a 3/16-inch nut driver to tighten the standoffs with two notches.
Caution Make sure that the standoffs are straight when installed. Tighten them gently but firmly. The shoulder of
each standoff must be seated tightly against the system board.
Figure 5 Installing the Power over Ethernet Card
1 Standoff hole without star pattern 4 Metal standoff with one notch
2 Standoff holes with star pattern 5 PoE card
3 Metal standoffs with two notches 6 Screws
247102
1
2
5
4
6
3
To Next Page
Loading...
