Cisco AIR-ANT2544V4M-R - Mounting on a Mast

12
Cisco Aironet Dual-Band MIMO Wall-Mounted Omnidirectional Antenna (AIR-ANT2544V4M-R)
78-20770-01
Installing the Antenna
Figure 6 Mounting on a Ceiling
Mounting on a Mast
The antenna can be mounted on a mast rather than on a wall using two 1/2 inch-wide hose clamps (not
provided).
To mount the antenna on a mast, follow these steps:
Step 1 Follow Steps 1 and Step 2 from the “Mounting on a Vertical Surface” section on page 8.
Step 2 Position the antenna, mounting bracket, and hose clamps on the mast.
Step 3 Tighten the hose clamps until the antenna is secure on the mast.
Once the antenna is secured on the mast, you can adjust the azimuth and elevation.