Cisco AS5350XM

Configuring Voice over IP
Configuring Basic VoIP
9
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
numbering-type
Sets calling/called party numbering type.
port
Sets voice port associated with the peer.
preference
Configures preference order of the peer.
prefix
Sets prefix to be dialed before the dialed number.
progress_ind
Indicates call progress.
register
Registers E.164 number of this peer with gatekeeper.
resource
Sets resource allocation policy.
session
Sets session [target | protocol | transport] for this peer.
shutdown
Changes administrator state of this peer to down.
translate-outgoing
Sets translation rule.
Table 17 VoIP Dial-Peer Configuration Commands
Command Purpose
acc-qos
Sets minimally acceptable quality of service for calls to this peer.
answer-address
Sets call destination number.
application
Sets selected application.
clid_restrict
Restricts display of caller ID.
codec
Sets codec for calls to this peer.
default
Set a command to its defaults.
destination-pattern
Sets full E.164 telephone number.
dtmf-relay
Transports DTMF digits across IP link.
exit
Exits dial-peer configuration mode.
expect-factor
Sets expectation factor for voice quality.
fax
Configures fax service.
fax-relay
Sets fax-relay options.
huntstop
Stops hunting on dial peers.
icpif
Sets calculated planning-impairment factor.
incoming
Sets incoming called number.
information-type
Sets information type for dial peer.
ip
Sets IP packet options.
max-conn
Sets maximum connections per peer; “no” sets to unlimited.
max-redirects
Sets maximum redirects for this peer.
no
Negates a command or sets its defaults.
numbering-type
Sets calling or called party numbering type.
preference
Configures preference order of the peer.
Table 16 POTS Dial-Peer Configuration Commands (continued)
Command Purpose