Cisco AS5350XM - Page 56

Verifying Basic Setup
Using the Interface Queue Wedge Monitor
12
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
AS5400#
Step 2 Show interfaces. (In this case, some interfaces are already wedged.)
AS5400# show wedged-interfaces output
Interface Name Time Since Wedge
Async4/00 00:23:33
Async4/01 00:23:26
Async4/02 00:23:21
Async4/03 00:23:15
GigabitEthernet0/0 00:24:35
GigabitEthernet0/1 00:24:50
Virtual-Access2 00:38:19
Virtual-Access3 00:38:19
AS5400#
Step 3 Show the interface wedge process running.
AS5400# show proc cpu | i Intf
39 0 341 0 0.00% 0.00% 0.00% 0 Intf Wedge Monit
AS5400#
Step 4 Disable the interface monitor.
AS5400# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
AS5400#(config)# no interface-monitor enable
AS5400#(config)# ^Z
AS5400#
AS5400#
Step 5 Show the interface wedge process running again. (No process is running now.)
AS5400# show proc cpu | i Intf
AS5400#
Step 6 Show the wedged interface output. (No output.)
AS5400# show wedged-interfaces output
Interface Name Time Since Wedge
AS5400#
AS5400#
Step 7 Enable the Interface Queue Wedge Monitor again.
AS5400# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
AS5400#(config)# interface-monitor enable
AS5400#(config)# ^Z
AS5400#
00:39:03: %HHM-3-INTFWEDGE: Async4/00 Output Queue Wedged
00:39:04: %SYS-5-CONFIG_I: Configured from console by console
00:39:06: %HHM-3-INTFWEDGE: Async4/01 Output Queue Wedged
00:39:09: %HHM-3-INTFWEDGE: Async4/02 Output Queue Wedged
00:39:12: %HHM-3-INTFWEDGE: Async4/03 Output Queue Wedged
00:39:15: %HHM-3-INTFWEDGE: GigabitEthernet0/0 Output Queue Wedged
00:39:18: %HHM-3-INTFWEDGE: GigabitEthernet0/1 Output Queue Wedged
00:39:39: %HHM-3-INTFWEDGE: Virtual-Access2 Output Queue Wedged
00:39:42: %HHM-3-INTFWEDGE: Virtual-Access3 Output Queue Wedged
AS5400#
AS5400#
AS5400#
Step 8 Show wedge output.