Cisco AS5350XM - Page 57

Verifying Basic Setup
Using the Interface Queue Wedge Monitor
13
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
AS5400# show wedge output
Interface Name Time Since Wedge
Async4/00 00:25:26
Async4/01 00:25:20
Async4/02 00:25:15
Async4/03 00:25:08
GigabitEthernet0/0 00:26:29
GigabitEthernet0/1 00:26:44
Virtual-Access2 00:40:12
Virtual-Access3 00:40:12
AS5400#
Step 9 Show the interface wedge process running again. (Process is running now.)
AS5400# show proc cpu | i Intf
39 0 25 0 0.00% 0.00% 0.00% 0 Intf Wedge Monit
Wedge Interface Input Procedure
The following procedure shows an example of how to enable, disable, and show the results of wedged
interface input:
Step 1 Show wedged interfaces. (Interfaces are already wedged.)
AS5400# show wedged-interfaces input
Interface Time Since Wedge
Async4/00 00:21:58
Async4/01 00:21:51
Async4/02 00:21:26
Async4/03 00:21:21
GigabitEthernet0/0 11:58:28
GigabitEthernet0/1 11:58:46
Virtual-Access2 00:08:46
Virtual-Access3 00:08:46
AS5400#
AS5400#
Step 2 Show the interface wedge process running.
AS5400# show proc cpu | i Intf
39 0 21 0 0.00% 0.00% 0.00% 0 Intf Wedge Monit
AS5400#
AS5400#
AS5400#
Step 3 Disable the interface monitor.
AS5400# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
AS5400#(config)# no interface-monitor enable
AS5400#(config)# ^Z
AS5400#
AS5400#
AS5400#
Step 4 Show the interface wedge process running again. (No process is running now.)
AS5400# show proc cpu | i Intf
AS5400#
AS5400#