Cisco ASA 5515-X Easy Setup Guide

16
17
16
Click [Next].
The ASA can be remotely man-
aged from an Auto Update
Server. This includes automatic
updating the ASA configuration,
ASA image, ASDM image as
needed.
17
Click [Finish].
You have completed the Startup
Wizard. To send your changes
to the ASA, click [Finish]. If you
want to modify any of the data,
click [Back].
3-3 Connecting Switch to ASA
After completing the Startup Wizard, exit the ASDM and disconnect the Ethernet
cable from your PC. Then, follow these steps to connect your switch to the ASA.
Make sure that nothing is connected to the switch, its settings are configured to
use DHCP, and the first Ethernet cable is still connected between the ASA and your
WAN device.
1
2
1
Connect the second Eth-
ernet cable to the Ethernet
port #2 of the ASA, and
the other end of the cable
to the Ethernet port of your
switch.
2
Connect the third Ethernet
cable to the Ethernet man-
agement port of the ASA,
and the other end of the
cable to the Ethernet port
of your switch.
WAN Device
Switch
Cisco ASA with FirePOWER Services Easy Setup Guide
3
Configuring ASA

Cisco ASA 5515-X Specifications

General

Firewall Throughput	1.2 Gbps
Maximum Concurrent Sessions	250, 000
VPN Throughput	200 Mbps
Maximum VPN Peers	250
Interfaces	6 x Gigabit Ethernet
IPsec VPN Throughput	200 Mbps
Memory	4 GB
Flash Memory	4 GB
Form Factor	1RU
IPS Throughput	250 Mbps
Concurrent Sessions	250, 000
Security Contexts	2
Power Supply	AC power supply (100-240V)