Need help?Do you have a question about the Cisco ASA 5550 Series and is the answer not in the manual?
General| Maximum VPN Peers | 2500 |
|---|---|
| Maximum Concurrent Connections | 400, 000 |
| Memory | 2 GB |
| Flash Memory | 256 MB |
| Interfaces | 8 x 10/100/1000 Ethernet |
| Power Supply | Dual power supplies |
| Form Factor | Rack-mounted |
Describes the adaptive security appliance's internal buses providing Gigabit Ethernet connectivity.
Explains how to distribute traffic equally between buses for optimal performance.
Guides the user on the next steps after completing this chapter.
Details how to verify all necessary items are present in the packing box for installation.
Provides instructions for rack-mounting and installing the adaptive security appliance chassis.
Explains the procedure for installing field-replaceable SFP modules for fiber connections.
Describes the front and rear panel ports and their associated LEDs.
Directs the user to the next chapter for further configuration steps.
Details how to connect Console, Auxiliary, Management, copper, and fiber Ethernet ports.
Guides the user to the next chapter for appliance configuration.
Explains the initial configuration for quick startup and management interface setup.
Introduces ASDM as a graphical interface for managing and monitoring the appliance.
Details how to use the Startup Wizard to simplify initial appliance configuration.
Describes changing the media type setting for fiber connections in Slot 1.
Points to subsequent chapters for further deployment configurations.
Illustrates a typical network layout for DMZ implementations of the adaptive security appliance.
Guides on using ASDM to configure the appliance for a DMZ scenario with sample parameters.
Suggests next steps for refining configuration or daily operations.
Shows an appliance configured to accept IPsec connections from VPN clients over the Internet.
Describes configuring the appliance to accept IPsec VPN connections from remote clients.
Guides on refining configuration or learning about daily operations after setup.
Initiates the Cisco Adaptive Security Device Manager (ASDM) application for configuration.
Sets up the first adaptive security appliance for the site-to-site VPN connection.
Specifies details about the remote VPN peer, including IP address and authentication method.
Sets up the Internet Key Exchange (IKE) policy for secure VPN tunnel negotiation.
Defines the encryption and authentication algorithms for the IPsec VPN tunnel.
Identifies local and remote hosts/networks permitted to use the IPsec tunnel.
Reviews the configured VPN tunnel attributes and finalizes the wizard.
Guides on refining configuration or learning about daily operations after setup.
To Next Page