CHAPTER
5-1
Cisco ASA 5550 Getting Started Guide
78-17644-01
5
Configuring the Adaptive Security
Appliance
This chapter describes the initial configuration of the adaptive security appliance.
You can perform the configuration steps using either the browser-based Cisco
Adaptive Security Device Manager (ASDM) or the command-line interface
(CLI). However, the procedures in this chapter refer to the method using ASDM.
Note To use ASDM, you must have a DES license or a 3DES-AES license. For more
information, see Appendix A, “Obtaining a DES License or a 3DES-AES
License.”
This chapter includes the following sections:
• About the Factory-Default Configuration, page 5-2
• About the Adaptive Security Device Manager, page 5-2
• Using the Startup Wizard, page 5-3
• Setting the Media Type for Fiber Interfaces, page 5-6
• What to Do Next, page 5-7
To Next Page
Loading...
