Cisco ASA 5550 Series

Chapter 3 Installing the Cisco ASA 5550 Security Appliance
Installing SFP Modules
3-8
Cisco ASA 5550 Getting Started Guide
78-17644-01
Figure 3-4 Installing an SFP Module
Caution Do not remove the port plugs from the SFP module until you are ready to connect
the cables.
Step 2 Remove the port plug; then connect the network cable to the SFP module.
Step 3 Connect the other end of the cable to your network. For more information on
connecting the cables, see Chapter 4, “Connecting Cables to Network Interfaces.”
Caution The latching mechanism used on many SFP modules locks them into place when
cables are connected. Do not pull on the cabling in an attempt to remove the SFP
module.
1 Port plug 3 SFP module
2 Port slot
132985
1
3
2