8-13
Cisco ASA 5550 Getting Started Guide
78-17644-01
Chapter 8 Scenario: Site-to-Site VPN Configuration
Configuring the Other Side of the VPN Connection
Configuring the Other Side of the VPN Connection
You have just configured the local adaptive security appliance. Now you need to
configure the adaptive security appliance at the remote site.
At the remote site, configure the second adaptive security appliance to serve as a
VPN peer. Use the procedure you used to configure the local adaptive security
appliance, starting with the “Configuring the Security Appliance at the Local
Site” section on page 8-4 and finishing with the “Viewing VPN Attributes and
Completing the Wizard” section on page 8-11.
Note When configuring Security Appliance 2, enter the exact same values for each of
the options that you selected for Security Appliance 1. Mismatches are a common
cause of VPN configuration failures.
What to Do Next
If you are deploying the adaptive security appliance solely in a site-to-site VPN
environment, you have completed the initial configuration. In addition, you may
want to consider performing some of the following steps:
To Do This ... See ...
Refine configuration and configure
optional and advanced features
Cisco Security Appliance Command
Line Configuration Guide
Learn about daily operations Cisco Security Appliance Command
Reference
Cisco Security Appliance Logging
Configuration and System Log
Messages
To Next Page
Loading...
