Cisco ASA 5550 Series

CHAPTER
4-1
Cisco ASA 5550 Getting Started Guide
78-17644-01
4
Connecting Cables to Network
Interfaces
This chapter describes how to connect the appropriate cables to the Console,
Auxiliary, Management, copper Ethernet, and fiber Ethernet ports.
This chapter includes the following sections:
• Connecting Interface Cables, page 4-1
• What to Do Next, page 4-7
Warning Only trained and qualified personnel should install, replace, or service this
equipment . Statement 49
Caution Read the safety warnings in the Regulatory Compliance and Safety Information for
the Cisco ASA 5500 Series and follow proper safety procedures when performing
these steps.
Connecting Interface Cables
To connect cables to the network interfaces, perform the following steps:
Step 1 Place the chassis on a flat, stable surface, or in a rack (if you are rack-mounting it).
Step 2 Connect to the Management port.