Chapter 6 Scenario: DMZ Configuration
Configuring the Security Appliance for a DMZ Deployment
6-12
Cisco ASA 5550 Getting Started Guide
78-17644-01
The displayed configuration should be similar to the following:
Step 3 Confirm that the configuration values are correct.
Step 4 Click Apply in the main ASDM window.
Configuring NAT for Inside Clients to Communicate with the DMZ
Web Server
In the previous procedure, you created a pool of IP addresses that could be used
by the adaptive security appliance to mask the private IP addresses of inside
clients.
To Next Page
Loading...
