EasyManua.ls Logo

Cisco ASA 5515-X - Page 27

Cisco ASA 5515-X
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Step 7 Enter setup, and configure network settings for the Management interface to establish temporary connectivity
to the HTTP or FTP server so that you can download and install the system software package.
If you have a DHCP server, the FTD automatically sets the network configuration. See the following
sample startup messages when using DHCP:
Configuring network interface using DHCP
Bringing up network interface.
Depending on your network, this might take a couple of minutes when using DHCP...
ifup: interface lo already configured
Using IPv4 address: 10.123.123.123
Using IPv6 address: fe80::2a0:c9ff:fe00:0
Using DNS server: 64.102.6.247
Using DNS server: 173.36.131.10
Using default gateway: 10.123.123.1
Note
Example:
Cisco FTD Boot 6.3.0
Type ? for list of commands
firepower-boot>
firepower-boot>setup
Welcome to Cisco FTD Setup
[hit Ctrl-C to abort]
Default values are inside []
Enter a hostname [firepower]: example.cisco.com
Do you want to configure IPv4 address on management interface?(y/n) [Y]: y
Do you want to enable DHCP for IPv4 address assignment on management interface?(y/n) [Y]:
n
Enter an IPv4 address: 10.123.123.123
Enter the netmask: 255.255.255.0
Enter the gateway: 10.123.123.1
Do you want to configure static IPv6 address on management interface?(y/n) [N]: n
Stateless autoconfiguration will be enabled for IPv6 addresses.
Enter the primary DNS server IP address [64.102.6.247]: 10.123.123.2
Do you want to configure Secondary DNS Server? (y/n) [y]: n
Any previously configured secondary DNS servers will be removed.
Do you want to configure Local Domain Name? (y/n) [n]: n
Do you want to configure Search domains? (y/n) [y]: n
Any previously configured search domains will be removed.
Do you want to enable the NTP service? [N]: n
Please review the final configuration:
Hostname: example.cisco.com
Management Interface Configuration
IPv4 Configuration: static
IP Address: 10.123.123.123
Netmask: 255.255.255.0
Gateway: 10.123.123.1
IPv6 Configuration: Stateless autoconfiguration
DNS Configuration:
DNS Server:
10.123.123.2
NTP configuration: Disabled
Cisco ASA and Firepower Threat Defense Reimage Guide
27
Cisco ASA and Firepower Threat Defense Reimage Guide
Reimage the Firepower Threat Defense Device

Other manuals for Cisco ASA 5515-X

Related product manuals