Cisco ASA 5540 - Page 1805

Index
IN-9
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
enabling logging 71-6
enabling secure logging 71-19
enrolling
certificate
35-9
Entrust, CA server support 35-7
established command, security level requirements 8-6
Ethernet
Auto-MDI/MDIX
8-5
duplex 8-8
jumbo frames, ASA 5580 8-32
jumbo frame support
single mode
8-26
MTU 8-26
speed 8-8
EtherType access list
compatibilty with extended access lists
30-2
implicit deny 30-3
evaluation license 4-12
extended ACL 15-2, 64-16
External Group Policy, add or edit 64-6
F
factory default configuration
commands
2-5
restoring 2-5
failover
about
57-1
about virtual MAC addresses 59-11
Active/Active, See Active/Active failover
Active/Standby, See Active/Standby failover
configuration file
terminal messages, Active/Active
60-3
terminal messages, Active/Standby 59-2
contexts 59-2
criteria 59-10, 60-12
debug messages 57-13
defining standby IP addresses 59-8, 59-9
disabling 59-12, 60-17
enable 60-10
enabling Stateful Failover 59-7
Ethernet failover cable 57-3
failover link 57-3
forcing 59-12, 60-17
health monitoring 57-10
in multiple context mode 60-9
interface health 57-11
interface monitoring 57-11
interface tests 57-11
key 60-10
link communications 57-3
MAC addresses
about
59-2
automatically assigning 6-11
monitoring, health 57-10
network tests 57-11
primary unit 59-2
redundant interfaces 8-12
reset 60-18
restoring a failed group 59-13, 60-17
restoring a failed unit 59-13, 60-17
secondary unit 59-2
SNMP syslog traps 57-13
Stateful Failover 60-11
Stateful Failover, See Stateful Failover
state link
57-3
system log messages 57-13
system requirements 57-2
Trusted Flow Acceleration 7-2, 55-6, 56-3, 73-5
type selection 57-5
unit health 57-11
failover groups
about
60-12
adding 60-13
editing 60-13
monitoring 60-19
reset 60-19
fast path 1-19