Cisco ASA 5540

22-7
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 22 Configuring RIP
Customizing RIP
– Ver sio n 2
– Version 1 & 2
Unchecking this check box restores the global setting.
• Override Global Receive Version—Check this check box to specify the RIP version accepted by
the interface. If a RIP updated from an unsupported version of RIP is received by the interface, it is
dropped. Choose one of the following options:
– Ver sio n 1
– Ver sio n 2
– Version 1 & 2
Unchecking this check box restores the global setting.
• Enable Authentication—Check this check box to enable RIP authentication. Uncheck this check
box to disable RIP authentication.
– Key—The key used by the authentication method, which can be up to 16 characters long.
– Key ID—The key ID. Valid values are from 0 to 255.
– Authentication Mode—You can choose one of the following authentication modes:
MD5—Uses MD5 for RIP message authentication.
Text—Uses cleartext for RIP message authentication (not recommended).
Step 6 Click Apply.
Configuring the RIP Send and Receive Version on an Interface
You can override the globally-set version of RIP that the adaptive security appliance uses to send and
receive RIP updates on a per-interface basis.
To configure the RIP version for sending and receiving updates, perform the following steps:
Step 1 In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step 2 Check the Enable RIP routing box, and click Apply.
Step 3 Choose Configuration > Device Setup > Routing > RIP > Interfaces.
Step 4 Click Edit.
The Edit RIP Interface Entry dialog box appears and allows you to configure the interface-specific RIP
settings for sending and receiving.
Step 5 In the Send Version area, check the Override global send version check box to specify the RIP version
sent by the interface. Choose one of the following:
• Ve rsi on 1
• Ve rsi on 2
• Version 1 & 2
Unchecking this check box restores the global setting.