Cisco ASA 5540

37-60
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 37 Configuring Inspection of Basic Internet Protocols
TFTP Inspection
8bit
base64
binary
others
quoted-printable
– Add—Adds the selected parameter from the Available Encodings table to the Selected
Encodings table.
– Remove—Removes the selected command from the Selected Commands table.
– Action—Reset, Drop Connection, Log.
– Log—Enable or disable.
• Sender Address Criterion Values—Specifies the value details for sender address match.
– Regular Expression—Lists the defined regular expressions to match.
– Manage—Opens the Manage Regular Expressions dialog box, which lets you configure regular
expressions.
– Regular Expression Class—Lists the defined regular expression classes to match.
– Manage—Opens the Manage Regular Expression Class dialog box, which lets you configure
regular expression class maps.
– Action—Reset, Drop Connection, Log.
– Log—Enable or disable.
• Sender Address Length Criterion Values—Specifies the value details for sender address length
match.
– Greater Than Length—Sender address length in bytes.
– Action—Reset, Drop Connection, Log.
– Log—Enable or disable.
Modes
The following table shows the modes in which this feature is available:
TFTP Inspection
TFTP inspection is enabled by default.
TFTP, described in RFC 1350, is a simple protocol to read and write files between a TFTP server and
client.
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
••••—