To Next PageTo Next Page
Need help?Do you have a question about the Cisco C1000-8P-2G-L and is the answer not in the manual?
General| Model | C1000-8P-2G-L |
|---|---|
| Device Type | Switch |
| PoE Ports | 8 |
| Gigabit Ethernet Ports | 8 |
| SFP Ports | 2 |
| PoE | Yes |
| Layer | Layer 2 |
| Switching Capacity | 20 Gbps |
| Forwarding Rate | 14.88 Mpps |
| DRAM | 512 MB |
| Flash Memory | 256 MB |
| VLAN Support | Yes |
| Jumbo Frame Support | Yes |
| Power Supply | Internal |
| MAC Address Table Size | 8000 entries |
| Operating Temperature | 0 to 45 °C |
| Operating Humidity | 10% to 90% (non-condensing) |
Critical safety precautions to follow during installation and operation.
Provides guidelines for proper switch installation environment and placement.
Steps to verify the switch passes POST before final installation.
Instructions for physically mounting the switch in various configurations.
Instructions for installing Small Form-factor Pluggable modules.
Details on connecting devices to PoE and PoE+ enabled ports.
Overview of troubleshooting methods using LEDs, CLI, and SNMP.
Information on Power-On Self-Test (POST) failures and contacting support.
Explanation of system LED status and their meanings.
Troubleshooting issues related to cables, ports, and link status.
Addressing issues related to port speed, duplex, and autonegotiation.
Initial switch setup via a guided wizard for network connectivity.
Accessing and managing the switch via Command Line Interface.
Connecting via RJ-45 and USB console ports, including driver management.
