EasyManuals Logo
Home>Cisco>Wireless Access Point>C9124AXE

Cisco C9124AXE User Manual

Cisco C9124AXE
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
The C9124AX Series AP uses an internal omni BLE antenna.
Note
Available in three model SKUs: Omni (-I) antenna (C9124AXI-x), Directional (-D) antenna
(C9124AXD-x), and External (-E) antenna (C9124AXE-x).
Four dual-band 2.4-GHz and 5-GHz integrated antennas on the C9124AX AP models (C9124AXI-x and
C9124AXD-x).
Four dual-band 2.4-GHz and 5-GHz, and two 5-GHz antenna ports on the C9124AXE AP model
(C9124AXE-x).
The x in the model numbers represents the regulatory domain. For information about supported regulatory
domains, see AP Model Numbers and Regulatory Domains, on page 3.
Note
MU-MIMO technology for uplink and downlink.
OFDMA-based scheduling for both uplink and downlink.
Multigigabit Ethernet (mGig)
The following hardware external interfaces:
1x100/1000/2500 Multigigabit Ethernet (PD or PoE-IN)
1xSFP port (Uplink)
1x1G Ethernet port (PSE or PoE-Out)
RS-232 Console Interface through RJ-45
Recovery push button (enables partial or full system configuration recovery)
One multicolor LED status indicator. For information about the colors of the LED status indicator,
see Checking the Access Point LEDs, on page 82.
Integrated Bluetooth Low Energy (BLE) radio enables IoT use cases such as location tracking and
wayfinding.
Cisco RF ASIC, a fully integrated Software Defined Radio (SDR), can perform advanced radio frequency
(RF) spectrum analysis, and deliver features such as next-generation CleanAir, Wireless Intrusion
Prevention System (WIPS), Dynamic Frequency Selection (DFS) detection.
Intelligent Capture probes the network and provides Cisco Digital Network Architecture (DNA) Center
with in-depth analysis.
Spatial Reuse (also known as Basic Service Set [BSS] coloring) allows the AP and their clients to
differentiate between BSS, thus permitting simultaneous transmissions.
A new power savings mode called Target Wake Time (TWT) allows clients to stay asleep and wake up
only at prescheduled (target) times to exchange data with the AP. This mode provides significant energy
savings for battery-operated devices.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
2
About the Cisco Catalyst 9124AX Series Outdoor Access Point
Cisco Catalyst 9124AX Series Outdoor Access Point Features

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco C9124AXE and is the answer not in the manual?

Cisco C9124AXE Specifications

General IconGeneral
BrandCisco
ModelC9124AXE
CategoryWireless Access Point
LanguageEnglish

Related product manuals