Cisco Catalyst 3560-E - Before Attaching the Brackets

14
Before Attaching the Brackets
To install the switch in a rack, you must first remove the screws from the switch chassis so that the
mounting brackets can be attached. For attachment at the front-mounting position remove two
Phillips truss-head screws from the switch side panels. For some switch models, remove only one screw
from the side panels. For attachment at the mid-mounting position, remove one screw. For attachment
at the rear-mounting position, remove one or two screws depending on the switch model.
200053
4
9
51
X
2-1
X
2-2
50
52
41
42
43
44
45
46
47
48
47X
48X
Catalyst 3560-E
SERIES
PoE-48