Cisco Catalyst 9120AX Series User Manual

24
Cisco Catalyst 9120AX Series Access Points
Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to
co-channel mobile satellite systems.
La bande 5 150-5 250 MHz est réservés uniquement pour une utilisation à l'intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.
Users are advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350
MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.
Les utilisateurs êtes avisés que les utilisateurs de radars de haute puissance sont désignés utilisateurs principaux
(c.-à-d., qu'ils ont la priorité) pour les bandes 5 250-5 350 MHz et 5 650-5 850 MHz et que ces radars pourraient causer
du brouillage et/ou des dommages aux dispositifs LAN-EL.
European Community, Switzerland, Norway, Iceland, and Liechtenstein
Access Point Models:
C9120AXI-E
Note This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain
frequencies and/or may require a license for operation. For more details, contact Cisco Corporate
Compliance.
The product carries the CE Mark:
Declaration of Conformity for RF Exposure
This section contains information on compliance with guidelines related to RF exposure.
Generic Discussion on RF Exposure
The Cisco products are designed to comply with the following national and international standards on Human Exposure
to Radio Frequencies:
 US 47 Code of Federal Regulations Part 2 Subpart J
 American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers / IEEE C 95.1 (99)
 International Commission on Non Ionizing Radiation Protection (ICNIRP) 98
 Ministry of Health (Canada) Safety Code 6. Limits on Human Exposure to Radio Frequency Fields in the range from
3kHz to 300 GHz
Antenna Type Antenna Gain Antenna Impedance
Single-band Omni 3 dBi 50 ohms
Dual-band Omni 3/5 dBi 50 ohms
Dual-band Omni 4/5 dBi 50 ohms
Single-Band HPOL 5 dBi 50 ohms

Cisco Catalyst 9120AX Series Specifications

General

Frequency Bands	2.4 GHz and 5 GHz
Antenna Type	Internal Antennas
PoE	802.3at PoE+
Wi-Fi Standard	802.11ax
MIMO	4x4 MU-MIMO
Weight	1.2 kg
Form Factor	Ceiling mount
Ethernet Ports	1 x 10/100/1000/2500 Multigigabit Ethernet port (RJ-45)
Dimensions	8.7 x 8.7 x 2.2 in