5G Sub-6 GHz Pluggable Interface Module
This chapter contains the following sections:
• 5G Sub-6 GHz Support on IoT Routing, on page 1
• 5G Pluggable Interface Module Overview, on page 2
• LED Behaviors, on page 3
• RF Band and Port Mapping for the P-5GS6-GL and P-5GS6-R16SA Antenna, on page 4
• Attaching an Antenna, on page 6
5G Sub-6 GHz Support on IoT Routing
The 5G Sub-6 GHz Pluggable Interface Modules offer 5G capability to the IoT Industrial Router family. The
product IDs for the pluggable modules are P-5GS6-GL and P-5GS6-R16SA. The P-5GS6-GL uses the FN980
Telit modem, and P-5GS6-R16SA uses the EM9293 modem.
• IOS XE release 17.7.1 is the first software release to provide support for the P-5GS6-GL.
• IOS XE release 17.13.1 is the first software release to provide support for the P-5GS6-R16SA.
Note
Features and Limitations
The following features and limitations apply across all IoT routing platforms unless specifically mentioned:
• IoT routing platforms support a maximum of two pluggable modules, with a combination of 5G and 4G
PIMs.
• The pluggable module can be started or stopped through the CLI under exec mode. Also, it can be
configured to power off the module to reduce power consumption as needed.
• The capability to disable FDD Band 30 for vehicular applications is available.
The following are product specific:
• On the IR1101 with P-5GS6-GL module:
• When plugged into the base, the module is accessible via Cellular 0/1/0, 0/1/1.
• The module is not supported on the expansion module.
5G Sub-6 GHz Pluggable Interface Module
1
To Next Page
Need help?
General
