Cisco CBS350-48P-4G User Manual

Get To Know Your Switch
This chapter contains the following sections:
• Introduction, on page 1
• Rack Mounting Switch, on page 2
• Wall Mounting a Switch, on page 3
• Stacking the Switches, on page 5
• Power over Ethernet Considerations, on page 7
• Front Panel, on page 9
• Configuring Switches, on page 11
• Restoring Factory Default Settings, on page 13
• Navigation, on page 14
Introduction
Thank you for purchasing the Cisco CBS Series Switch. The Cisco CBS Series Switches combine powerful
network performance and reliability with a complete suite of network features that you need for a solid business
network. These expandable Gigabit Ethernet switches, with Gigabit or 10-Gigabit uplinks, provide multiple
management options, rich security capabilities, and Layer-3 static routing features far beyond those of an
unmanaged or consumer-grade switch, at a lower cost than fully managed switches.
Before You Begin
Before you begin installing your device, ensure that the following items are available:
• RJ-45 Ethernet cables for connecting network devices. A category 6a and higher cable is required for
10G ports; a category 5e and higher cable is required for all other ports.
• Tools for installing the hardware.
• The rack-mount kit packed with the switch contains four rubber feet for desktop placement, and
two brackets and twelve screws for rackmounting.
• If the supplied screws are lost, use replacement screws in the following size:
• Diameter of the screw head: 6.9 mm
• Length of face of screw head to base of screw: 5.9 mm
• Shaft diameter: 3.94 mm
Get To Know Your Switch
1

Cisco CBS350-48P-4G Specifications

General

Brand	Cisco
Model	CBS350-48P-4G
Category	Switch
Language	English

Summary

Introduction to Cisco CBS Series Switch

Rack Mounting Switch

Guides on mounting the switch into a standard 19-inch rack chassis using supplied brackets.

Wall Mounting a Switch

Instructions for mounting the switch on a wall using studs or a plywood backboard with brackets.

Stacking the Switches

Explains how to connect multiple switches together using stack ports for increased capacity.

Power over Ethernet Considerations

Details switches supporting PoE, model numbers, and power requirements for connected devices.

Front Panel

Describes the physical components on the switch's front panel, including ports, LEDs, and the reset button.

Configuring Switches

Covers accessing and managing the switch via web-based or console interfaces, including default settings.

Restoring Factory Default Settings

Steps to reset the switch to its original factory default configuration using the reset button.

Navigation

Explains how to navigate the switch's web UI, including basic and advanced display modes.