2-20
Cisco Physical Access Gateway User Guide
OL-32499-01
Chapter 2 Installing and Configuring the Cisco Physical Access Gateway
Configuring and Managing the Gateway Using a Direct Connection
Procedure
To change the password used to access the Gateway, perform the following procedure:
Step 1 Click the User Management tab, as shown in Figure 2-14.
Figure 2-14 User Management for the Cisco Physical Access Gateway
Step 2
Enter the Current Password.
Step 3 Enter the New Password.
Step 4 Re-enter the new password to verify the setting.
Step 5 Click Update to save the changes.
Note The username cannot be changed.
Tip To reset the device to the default password, see the “Hard Reset (Restore Factory Defaults)” section on
page 2-25.
Upgrading the Gateway Firmware Using a Direct Connection
Tip You can also upgrade the firmware for a single Gateway, or all Gateways, over the network using the
Cisco PAM desktop software. For instructions, see the Cisco Physical Access Manager User Guide.
To Next Page
Loading...
