Cisco CIAC-GW-K9 - Configuring the Gateway Using the Cisco Physical Access Manager

2-24
Cisco Physical Access Gateway User Guide
OL-32499-01
Chapter 2 Installing and Configuring the Cisco Physical Access Gateway
Configuring the Gateway Using the Cisco Physical Access Manager
Tip The serial number is also displayed on the back of the module. To view the serial number in Cisco PAM,
open the Hardware module device view, right-click on the Gateway Controller, and choose Edit to
view the module properties.
Configuring the Gateway Using the Cisco Physical Access
Manager
After the initial Gateway configuration is complete, use the The Cisco Physical Access Manager
(Cisco PAM) desktop software for advanced configuration of Gateways and other components. For
example, you can use Cisco PAM to configure doors, door devices and access policies enabled by the
Gateway modules.
In addition, you can use Cisco PAM to do the following:
• Display the network and firmware settings for each Gateway.
• Change the Gateway module network settings.
• Change the NTP setting for multiple Gateway modules.
• Upgrade Gateway firmware images.
See the Cisco Physical Access Manager User Guide for more information.
Tip You can configure the Gateway modules in Cisco PAM before or after they are added to the IP network.