3 Insert the battery into the battery compartment. Do not force the battery into the
compartment, but be sure to press the battery all the way in until it seats fully.
Important: Take care to position the battery correctly. Insert the battery only as
shown in the following illustration.
4 Close the battery compartment door.
Important: After you install the Residential Gateway and plug it into an AC
electrical outlet as described in Install the Residential Gateway (on page 17), it
can take as long as 24 hours for the battery to charge fully. However, you can
begin using your high-speed Internet and telephone service immediately after
installation. See Normal Operations (AC Power Applied) (on page 40) for
information on how the LEDs on the front of the Residential Gateway indicate
the state of the battery charge.
To Next Page
Loading...
Need help?
General