Re-qualify additional coax outlets to support MoCA-enabled devices and
services.
Pre-Installation Instructions
Prior to installing MoCA, complete the following tasks:
1 Contact your service provider and ensure that the Residential Gateway is
enabled for MoCA services.
2 Ensure that a MoCA filter has been has been installed by your service provider at
the home’s entry point, as shown in the following illustration:
3 To log-in to the Residential Gateway, enter http://10.0.0.1 in the web address
(URL) field of any browser and press Enter. Then enter the following when
prompted
Username: admin
Password: password
4 From the menu options, go to Gateway/Connections/MoCA and ensure that
MoCA is set to ena ble.
5 If you have not already done so, connect the coaxial cable from a wall cable
outlet within the home network to the MoCA/Cable port on the rear panel of the
Residential Gateway.
6 If you have not already done so, connect the AC power cord provided with your
Residential Gateway. Connect the barrel connector end of the power cord into
the power input on the back of the Residential Gateway. Then, plug the other
end of the power cord into an AC outlet.
The Residential Gateway will perform an automatic search to locate and sign on
to the broadband data network. This process may take up to 2-5 minutes. The
Residential Gateway will be ready for use when the Powe r , US/DS, and Online
LEDs on the front panel of the residential gateway stop blinking and remain on
continuously.
To Next Page
Loading...
Need help?
General