Chapter 1 Introducing the EuroDOCSIS Wireless Residential Gateway with Voice
5 RESET—A momentary pressing (1-2 seconds) of this button performs a software
reset the device. Pressing and holding the button for more than ten seconds first
causes a reset-to-factory-default of all settings and then performs a software reset
of the device
CAUTION:
The RESET button is for maintenance purposes only. Do not use unless
instructed to do so by your service provider. Doing so may cause you to lose
any settings you have selected.
6 CABLE—F-connector connects to an active cable signal from your service
provider
7 POWER—Connects the residential gateway to the AC power adapter that is
provided with your residential gateway
8 ON/OFF SWITCH (Provided only on products that carry the CE mark)—
Allows you to turn off of the residential gateway without removing the power
cord. Turning the residential gateway off using this switch ensures that the unit
is consuming no energy.
To Next Page
Loading...
