Configure Applications and Gaming
Applications and Gaming Port Range Forward Page Description
Use the descriptions and instructions in the following table to configure the port
range forwarding for the residential gateway. Select enable for each. After you make
your selections, click Save Settings to apply your changes or Cancel Changes to
cancel.
Port Range Forwarding Start
For the Start port, select a port from the recommended 49152 -
65535 range. Keep in mind that ports used are program specific
so check which ones the program requires to be forwarded.
End
For the End port, select a port from the recommended 49152 -
65535 range. Keep in mind that ports used are program specific
so check which ones the program requires to be forwarded.
Protocol
Select one of the following protocols:
TCP
UDP
Both
IP Address
Enter the computer’s IP address to which this is to apply.
Enable
Check this box to enable port forwarding for the specified ports
and IP addresses.
To Next Page
Loading...
Need help?
General