Enable Block Title: Prevent Titles of Recordings Blocked by the Parental Control Feature From Showing
Using the Addressable Method to Enable the Block Title Setting
Important: To complete this procedure successfully, you must have the MAC
address of the DVR whose setting you want to enable.
1 On the DNCS Administrative Console, select the Server Applications tab.
2 Click DHCT Config. The DHCT Configure Prompt window opens.
3 Click Addressable. The Set Up Addressable DHCT Configuration window opens
with the Base Application tab in the forefront.
4 Type the MAC Address in the DHCT MAC Address field.
5 Select the IPG tab. The IPG tab moves to the forefront.
6 On the IPG tab, click to enable the setting Block Titles of Blocked Programs. The
Block Titles of Blocked Programs box changes from gray to yellow and the
setting is shown in bold to indicate that it has been changed from its original
setting and that it will be sent to the DVR.
Note: Because all changed settings are sent to the DVR, settings remain in bold
even if they are changed back to their original settings.
7 Click Send. The SARA server sends the new setting to the DVR that you
specified.
8 Do you need to customize other aspects of DVR service?
If yes, continue customizing the service by following the appropriate
procedure in this chapter.
If no, verify that DVR service functions according to the customizations you
have made. Go to Testing DVR Services (on page 37).
To Next Page
Loading...
Need help?
General
