58 4028315 Rev A
How Do I Configure My DOCSIS Residential Gateway?
Field Name Description
IPsec Endpoint Enables/disables the IP sec endpoint mode
Name Displays the user-defined tunnel name entered from the VPN Setup
page
Status Displays the current connection state (Connected/NOT Connected)
Control Displays one of the following three keys based on the current tunnel
enable and connection state:
Enable
Connect
Endpoint disabled
Configure Displays Edit or Delete keys used for settings management
Add New Tunnel Allows you to create a new tunnel configuration. When you click Add
New Tunnel, the VPN Setup page opens
Event Log Allows you to access the Event Log page. The Event Log page shows a
history of VPN connections and activity in chronological order and also
displays the IP address of both endpoints on the tunnel (local and
remote)
Note: On the Event Log page, pressing the Refresh key updates the
Event Log table to show any changes since the page was loaded.
Pressing the Clear key clears the log table of its current contents and
only the most recent data appears
To Next Page
Loading...
Need help?
General