Cisco Linksys E2500 User Manual

11
Advanced Dual-Band N Router
Linksys E2500 Chapter 1: Advanced Configuration
Passphrase Enter a passphrase of 8-63 characters. The
default is password. The setup software that you use
to install your Router and set up your wireless network
changes the default passphrase.
WPA Personal
NOTE: If you select WPA Personal as your
Security Mode, each device in your wireless
network MUST use WPA Personal and the same
passphrase.
WPA Personal
Passphrase Enter a passphrase of 8-63 characters. The
default is password. The setup software that you use
to install your Router and set up your wireless network
changes the default passphrase.
WEP
WEP is a basic encryption method, which is not as secure
as WPA.
IMPORTANT: If you select WEP as your Security
Mode, each device in your wireless network
MUST use WEP and the same encryption and
shared key.
WEP
Encryption Select a level of WEP encryption, 64 bits
10 hex digits or 128 bits 26 hex digits. The default is
64 bits 10 hex digits.
Passphrase Enter a Passphrase to automatically generate
WEP keys. Then click Generate.
Key 1-4 If you did not enter a Passphrase, enter the WEP
key(s) manually.
TX Key Select a default TX (Transmit) Key (choose which
Key to use). The default is 1.

Cisco Linksys E2500 Specifications

General

Model	E2500
Category	Network Router
Frequency Bands	2.4 GHz
Wireless Speed	300 Mbps
Wired Speed	10/100 Mbps
Ethernet Ports	4
Antenna Type	Internal
Firewall	SPI Firewall
Wireless Standard	802.11n
Security Features	WEP, WPA, WPA2
VPN Passthrough	IPSec, PPTP