Cisco Linksys WAP300N - Device Information and Firmware Management; Updating Your WAP300 N Firmware; Viewing Device and Local Network Information; Viewing Wireless Network Information

24
Maintaining and Monitoring
Linksys WAP300N
How to view device and local network
information
To view device and local network information:
1. Log into the browser-based utility (see “How to open the browser-based
utility” on page8).
2. Click the Status tab, then click the Device Info & Local Network page.
Device and network information appears.
Firmware Version—The device’s current firmware version.
Firmware Verification—Used by technical support to verify the
firmware.
MAC Address—The device’s Ethernet port MAC address.
IP Address—The device’s IP address, as seen on your local network.
Subnet Mask—The subnet mask configured for your local network.
Default Gateway—The default gateway configured for your local
network.
How to view wireless network
information
To view wireless network information:
1. Log into the browser-based utility (see “How to open the browser-based
utility” on page8).
2. Click the Status tab, then click the Wireless Network page. Wireless
network information appears. Available information depends on the
current operating mode, although the list below shows all possible fields.
Operation Mode—The current operation mode of the device.
MAC Address—The MAC address of the device’s wireless (Wi-Fi) interface.
Link Status—The status of the wireless connection.
Network Name (SSID)—The name of your wireless network.
Network Mode—Your wireless network’s network mode.
Channel Width—Your wireless network’s channel width (in MHz).
Radio Band—Your wireless network’s radio band (in GHz).
Channel—Your wireless network’s channel setting.
Security—Your wireless network’s security mode.