2
1
A Attach the Bridge’s antenna.
B Plug the included Ethernet
network cable into the LAN port
on the back panel of the
Bridge.
C The X-II (MDI/MDI-X) slide switch
offers a choice between two
settings. Slide the X-II switch to
the X position if you are
connecting the Bridge to a
PC’s network adapter. Slide the
X-II switch to the II position if
you are connecting the Bridge
to a hub or switch.
D Plug the other end of the
Ethernet network cable into the
RJ-45 port of the hub, switch,
or PC you wish to use to
configure the Bridge.
E Plug the supplied power
adapter into the Power port on
the back panel of the Bridge.
Then plug the other end into
an electrical outlet.
Connecting the Wireless-B
Ethernet Bridge for Setup
B
E
To Next Page
Loading...
