Cisco Linksys WET610N Configuring

Configuration instructions for WET610N Radio Rev0
Configuring the WET610N for use on the
FRC playing field
The WET610N must be configured manually for use on the playing field at an FRC event.
Figure 1: Linksys WET610N Radio
Instructions
1. Set IP address and subnet on PC used to configure radio
a. IP: 169.254.1.100
b. Subnet: 255.255.0.0
1. Power on the WET610N radio.
2. Using a paperclip, hold down the RESET button of the WET610N radio until the power light
begins flashing, then remove the paperclip.
3. Wait for the power light to turn solid blue
2. Connect an RJ45 Ethernet cable between the WET610N and the computer
3. Open a web browser and navigate to http://169.254.1.250
4. Login
a. Username: admin
b. Password: admin

Cisco Linksys WET610N Specifications

General

Model	WET610N
Device Type	Wireless-N Ethernet Bridge
Wireless Standards	IEEE 802.11n, IEEE 802.11g, IEEE 802.11b
Wireless Frequency Bands	2.4 GHz
Security	WPA2, WPA, WEP