Need help?Do you have a question about the Cisco Nexus 3064 and is the answer not in the manual?
General| Product Model | Nexus 3064 |
|---|---|
| Category | Switch |
| Switching Capacity | 1.28 Tbps |
| Form Factor | 1 RU |
| MAC Address Table Size | 32, 000 entries |
| Jumbo Frame Support | Yes |
| Jumbo Frame Size | 9216 bytes |
| Operating System | Cisco NX-OS |
| Memory | 4 GB |
| VLANs | 4096 |
| AC Input Voltage | 100 to 240 VAC |
| AC Input Frequency | 50 to 60 Hz |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Storage Temperature | -40°F to 158°F (-40°C to 70°C) |
| Ports | 48 x 10GE SFP+ |
| Airflow | Port-side exhaust or port-side intake |
| Humidity | 5% to 95% (non-condensing) |
| Power Supply | Dual hot-swappable power supplies |
Provides critical safety information and warnings for installing Cisco Nexus switches.
Explains various rack-mount kit options and rack types for installing Cisco Nexus switches.
Lists prerequisites and site requirements before installing the Cisco Nexus switch chassis.
Details the steps for safely unpacking and inspecting the Cisco Nexus switch chassis for damage.
Guides the installation of a 1 RU Cisco Nexus switch into a four-post rack using specific kits.
Details the process of installing a 1 RU Cisco Nexus switch into a two-post rack.
Guides the installation of a 2 RU Cisco Nexus switch into a four-post rack.
Details the installation of a 2 RU Cisco Nexus switch into a two-post rack using center-mount brackets.
Explains the procedures for properly grounding the Cisco Nexus switch chassis for safety.
Provides instructions on how to power up and verify the initial status of the Cisco Nexus switch.
Discusses site preparation and equipment gathering for establishing network connections to the switch.
Guides on connecting to the switch's console port for initial configuration and management.
Explains how to connect to the switch's management interface for initial IP configuration.
Guides on how to replace an AC power supply module in the Cisco Nexus switch.
Details the procedure for replacing a DC power supply module in the Cisco Nexus switch.
To Next Page