© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 19 of 29
●
CoS trust
●
Port-based CoS assignment
●
Modular QoS CLI (MQC) compliance - IPv4 and IPv6
●
ACL-based QoS classification (Layers 2, 3, and 4)
●
MQC CoS marking
●
Per-port virtual output queuing
●
CoS-based egress queuing
●
Egress strict-priority queuing
●
Egress port-based scheduling: Weighted Round-Robin (WRR)
●
Control Plan Policing (CoPP) - IPv4 and IPv6
Security
●
Ingress ACLs (standard and extended) on Ethernet and virtual Ethernet ports
●
Standard and extended Layer 2 ACLs: MAC addresses, protocol type, etc.
●
Standard and extended Layer 3 to 4 ACLs: IPv4 and IPv6, Internet Control Message Protocol (ICMP and ICMPv6), TCP, User Datagram
Protocol (UDP), etc.
●
VLAN-based ACLs (VACLs)
●
Port-based ACLs (PACLs)
●
Named ACLs
●
Optimized ACL distribution
●
ACLs on virtual terminals (VTYs)
●
ACL logging on management interface
●
Dynamic Host Configuration Protocol (DHCP) snooping with Option 82
●
Dynamic Address Resolution Protocol (ARP) Inspection
●
IP source guard
●
DHCP relay
●
Cisco CTS (Authentication and Policy download from ACS)
●
Ethernet Port Security
●
IPv6 RACL
●
IPv6 PACL
●
IPv6 VACL
High-Availability Features
●
In-Service Software Upgrade (ISSU) for Layer 2
●
Hot-swappable field-replaceable power supplies, fan modules, and expansion modules
●
1:1 power redundancy
●
N:1 fan module redundancy
Management
●
Switch management using 10/100/1000-Mbps management or console ports
●
CLI-based console to provide detailed out-of-band management
●
In-band switch management
●
Locator and beacon LEDs on Cisco Nexus 2000 Series
●
Port-based locator and beacon LEDs
●
Configuration synchronization
●
Module preprovisioning
●
Configuration rollback
●
Secure Shell Version 2 (SSHv2)
●
Telnet
●
AAA
●
AAA with RBAC
●
RADIUS
●
TACACS+
●
Syslog (8 servers)
●
Embedded packet analyzer
●
SNMPv1, v2, and v3 (IPv4 & IPv6)
●
Enhanced SNMP MIB support
●
XML (NETCONF) support
To Next Page
Loading...
