Configuring SNMP
Defining SNMP Communities
Cisco Small Business 300 Series Managed Switch Administration Guide 289
19
• Community String—Enter the community name (password) used to
authenticate the management station to the device.
• Basic—Select this mode for a selected community. In this mode, there is no
connection to any group. You can only choose the community access level
(R/O, R/W, or Admin) and, optionally, further qualify it for a specific view. By
default, it applies to the entire MIB. If this is selected, enter the following
fields:
- Access Mode—Select the access rights of the community. The options
are:
Read Only—Management access is restricted to read-only. Changes
cannot be made to the community.
Read Write—Management access is read-write. Changes can be made
to the device configuration, but not to the community.
SNMP Admin—User has access to all device configuration options, as
well as permissions to modify the community. Admin is equivalent to
Read Write for all MIBs except for the SNMP MIBs. Admin is required for
access to the SNMP MIBs.
- View Name—Select an SNMP view (a collection of MIB subtrees to which
access is granted).
• Advanced—Select
this mode for a selected community.
- Group Name—Select an SNMP group that determines the access rights.
STEP 4 Click Apply. The SNMP Community is defined, and the switch is updated.
To Next Page
Loading...
