To Next PageTo Next Page
Need help?Do you have a question about the Cisco SG 300-52 and is the answer not in the manual?
General| Switching Capacity | 104 Gbps |
|---|---|
| Forwarding Rate | 77.38 Mpps |
| Jumbo Frame Support | 9216 bytes |
| Layer | Layer 3 |
| MAC Address Table Size | 16, 000 |
| Storage Temperature | -13 to 158°F |
| Operating Humidity | 10% to 90% non-condensing |
| Storage Humidity | 5% to 90% relative humidity, noncondensing |
| Dimensions (W x D x H) | 440 x 260 x 44 mm |
| Operating Temperature | 0°C to 45°C |
Explains how to access the switch's web interface for configuration.
Provides instructions for upgrading firmware, boot code, or language files and backing up.
Details how to perform cable tests on copper ports to check for faults and estimate length.
Explains how to configure port settings like speed, duplex, and administrative status.
Covers setting PoE power limits, modes (Port Limit/Class Limit), and generating traps.
Details the process of creating new VLANs with unique IDs and names.
Covers assigning ports and LAGs to VLANs and configuring their membership type.
Explains how to enable STP, RSTP, or MSTP and configure global parameters.
Details per-port configuration for Rapid Spanning Tree Protocol (RSTP) for faster convergence.
Describes how to assign static MAC addresses to specific interfaces and VLANs.
Explains IP addressing configuration for Layer 2 and Layer 3 modes.
Covers adding and managing user accounts for switch administration.
Explains how to assign authentication methods for management access (SSH, Telnet, etc.).
Details limiting port access based on specific MAC addresses.
Explains port-based network access control using 802.1X authentication.
Introduces Access Control Lists (ACLs) for filtering traffic based on defined patterns.
Details how to configure QoS modes (Basic, Advanced), class maps, and policers.
Covers configuration of IPv4 and IPv6 addresses, default routes, and network settings.
