Cisco SPA921 - Cisco - IP Phone - Internal Error Codes

Provisioning Field Reference
Internal Error Codes
Cisco Small Business IP Telephony Devices Provisioning Guide 94
4
Internal Error Codes
The IP Telephony Device defines a number of internal error codes (X00–X99) to
facilitate configuration in providing finer control over the behavior of the unit under
certain error conditions.
ERR Result message of resync or upgrade attempt.
Only useful in generating result syslog
messages. The value is preserved in the
UPGERR variable in the case of upgrade
attempts.
UID1 The contents of the Line 1 User_ID
configuration parameter (Firmware 2.0.11 and
above).
UID2 The contents of the Line 2 User_ID
configuration parameter (Firmware 2.0.11 and
above).
ISCUST Value=1 if unit is customized, 0 otherwise;
customization status viewable on WebUI Info
page.
Parameter Name Description and Default Value
Parameter Name Description and Default Value
X00 Transport layer (or ICMP) error when sending a
SIP request.
X20 SIP request times out while waiting for a
response.
X40 General SIP protocol error (for example,
unacceptable codec in SDP in 200 and ACK
messages, or times out while waiting for ACK).
X60 Dialed number invalid according to given dial
plan.