Cisco SR2024 - Chapter 2: Product Overview; Front Panel

3
Chapter 2: Product Overview
24-Port 10/100/100 Gigabit Switch
Chapter 2:
Product Overview
Front Panel
The LEDs and ports are located on the front panel of the Switch.
SR2024
24-Port 10/100/1000 Gigabit Switch
Link/Act
SYSTEM
Gigabit
miniGBIC2
miniGBIC1
Link/Act
Gigabit
(Shared with 24)(Shared with 12)
Front Panel
LEDs
System (Green) The System LED will light up when the
Switch is powered on.
Link/Act (Green) Each LED will light up when there is a
connection made through its corresponding port. It will flash
when there is activity on its corresponding port.
Gigabit (Amber) Each LED will light up when there is a Gigabit
connection made through its corresponding port. It will flash
when there is activity on its corresponding port.
Ports
1-24 The Switch is equipped with 24 auto-sensing RJ-45
ports. These RJ-45 ports support network speeds of either
10Mbps, 100Mbps, or 1000Mbps and can operate in half
and full-duplex modes. Auto-sensing technology enables
each port to automatically detect the speed of the device
connected to it and adjust its speed and duplex accordingly.
To connect a device to a port, you will need to use a network
cable. You will need to use Category 5 (or better) cables.