41
IX5000 Field-Replaceable Units and Country- and Region-Specific Power Connectors
Replacing a Microphone (Mic) Bar—Part Number CTS-5K-MIC=
Procedure
Step 1 Remove the mute button covers. This procedure is the same for either the first or second row.
Step 2 (Center first row microphone and all 2nd row microphones only) Remove the front panel from the table
section from which the mic bar will be removed.
Step 3 From underneath the table section, remove the screws that connect the mic bar to the table (six per mic
bar) using a #2 Phillips driver.
Note If a cable for the Touch 10 goes through the center of the mic bar, unscrew the screw that secures the mic
bar cap to the mic bar, disconnect the Ethernet cable from the Touch 10 device, and thread the Ethernet
cable out from the center of the mic bar,
To Next Page
Loading...
Need help?
General
