Cisco TelePresence IX5200 First-Time Setup

36
Cisco TelePresence IX5000 and IX5200 First-Time Setup
OL-27038-01
Performing First-Time Setup
Step 18 When the test completes, verify that all of the appropriate FTS tests show a green check mark. All nine
tests should show a check mark if your system includes a whiteboard. If your system does not include a
whiteboard, all tests should show a check mark, except Whiteboard Setup and Whiteboard Mic
Calibration.
Step 19 If your system includes auxiliary displays, you must reboot the system for the displays to be detected.
For more information, see “Reboot Required After First-Time Setup For Systems with Auxiliary
Displays” section on page 12.
Requirements for the Whiteboard Microphone
The whiteboard microphone is used when a person at the whiteboard is speaking. It allows participants
to be heard while they are presenting.
The whiteboard microphone must fit the following characteristics:
• The microphone must be omnidirectional (wireless or corded) and have a minimum frequency
response of 100Hz to 10KHz (+/- 3dB).
• The microphone must include an adjustable preamp with a gain knob and power supply (maximum
input voltage +3dBV).
• The output line must use a 3.5mm TRS connector to connect to the Host CPU codec.

Cisco TelePresence IX5200 Specifications

General

Brand	Cisco
Model	TelePresence IX5200
Category	Conference System
Language	English