2
Cisco TelePresence IX5000 and IX5200 First-Time Setup
OL-27038-01
Summary of Changes
Summary of Changes
The following table shows you the changes that have been made to this document.
Immediate Software Upgrade Requirements
Your IX system comes preloaded with a downlevel version of IX software. You must upgrade your
system to the latest version on Cisco.com before you use your system to place and receive calls.
Due to some issues with the preloaded software, make the following changes to your system before
you load the software (requires signing in to Unified CM and the IX system administration GUI):
• Make sure that your system is not configured for secure mode in Unified CM. After you perform the
upgrade, and after your system is registered to Unified CM, change the system settings in Unified
CM if secure mode is required.
• Make sure that a Certificate Trust List (CTL) is not present on your system and, if present, delete it.
–
To check, after initial system boot, log in to the IX System administration GUI (default
username and password is admin / cisco).
Date Summary of Change
April 17, 2017
• Added the “Requirements for Auxiliary Displays” section on page 11.
• Added step 5d. on page 19 in the “Performing First-Time Setup” to perform
camera alignment on two-table systems.
• Added Step 19 on page 36 in the “Performing First-Time Setup” section to
reboot the IX system if an auxiliary display is added.
• Changed the terminology of Touch 10 device to “Touch 10 controller”.
July 1, 2016
• Step 4c. of the procedure in the “Performing First-Time Setup” section on
page 15 was updated to add information on correct cabling for auxiliary
displays.
April 7, 2016
• Updated the “Immediate Software Upgrade Requirements” section on page 2
to include the path to the Download Software page.
• If the camera alignment fails with a Walnut table installation, more steps may
be required. Step 5 of “Performing First-Time Setup” section on page 15 has
been updated to include this information.
April 24, 2015
• If you configure a static IP address for your system, and a domain name is also
required, either use the set network IP static CLI command, or configure
your system in Mixed mode. The “Configuring an IX5000 or IX5200 System
With a Static Network Address” section on page 10 has been updated to
include this information.
• The “Configuring an Alternate TFTP Server (Optional)” section has been
removed, as that information is covered in Step 4 in the “Configuring Cisco
Unified Communications Manager for Your Cisco TelePresence System”
section on page 5.
• The title of the “Required First Time Power-On and Software Installation
Procedure” section on page 3 has been changed to correctly reflect its
content. The previous title was “Preventing Touch 10 Configuration Issues”.
To Next Page
Loading...
