Cisco TelePresence IX5200 First-Time Setup

18
Cisco TelePresence IX5000 and IX5200 First-Time Setup
OL-27038-01
Performing First-Time Setup
Hot swapping of cables is not supported. Be sure to boot or reboot your system after you make any
cabling changes.
Step 5 Perform camera alignment for your system. If you have a two-table system, proceed to step 5d.
a. Place the camera targets (included with the system) so that the line on the back of the target is flush
with the seams between the center and side tabletops.
b. Be sure that the rear edge of the target is flush with the rear edge of the table.
c. Be sure that the tabletop is clear, especially the rear edge, then click Continue to begin the test.
Proceed to step 5e.

Cisco TelePresence IX5200 Specifications

General

Brand	Cisco
Model	TelePresence IX5200
Category	Conference System
Language	English