Page 27
Connect the cable to the loudspeaker. Use
the cable that is marked with the correct
loudspeaker position.
1
Enter the loudspeaker onto the speaker clip.
Make sure that no cables are pinched.
2
3
Fasten with one screw.
8 ×
PT4x10 (one for each loudspeaker)
Two loudspeakers are preinstalled. Follow
steps 1-3 for the remaining eight loudspeakers.
1
5
2
3
4
1
5
2
3
4
The loudspeaker cables
are marked with a number.
These numbers must
match the position of the
loudspeakers, as shown
here.
To Next Page
Loading...
