Preliminary User Guide for SX10
Produced: 01.2014
All contents © 2014
Cisco Systems, Inc. All rights reserved.
The upper left eld provides
access to Settings and Standby.
The Settings will normally be
password protected by your
system administrator.
If you move the cursor to Standby
and press OK, the system will
immediately enter Standby.
You may also select between being
Available or not (called Do not
disturb).
In the Do not disturb mode you
will be able to place calls as usual,
but anyone trying to call you will
perceive you as not being present.
To exit this eld, press the back
arrow, if needed.
Getting started
Accessing the Settings
Move cursor to this eld and press OK (Center key on the remote control).
1 2 3
4 5 6
7 8 9
*
0
#
.@
pqrs tuv wxyz
defabc
ghi jkl mno
Available
is currently
selected.
Keys used
for this.
To access the
Settings move
cursor to here
and press OK.
To put system
in Standby
immediately,
move cursor to
here and press
OK.
The options available
To Next Page
Loading...
