Cisco TelePresence System Codec C-Series User Manual (English)

To Next Page

To Previous Page

105

Cisco TelePresence System Codec C40/C60 and Profiles using C40/60 Administrator Guide

SystemUnit IrSensor

Both the Codec C Series and PrecisionHD camera have IR sensors, and only one of them

needs to be enabled at the time. The IR sensor LED is located on the front of the codec and the

camera and flickers when an IR signal is received from the remote control.

Requires user role: ADMIN

Value space: <Auto/Off/On>

Auto: The system will automatically disable the IR sensor on the codec if the IR sensor at

camera is enabled. Otherwise, the IR sensor on the codec will be enabled.

Off: Disable the IR sensor on the codec.

On: Enable the IR sensor on the codec.

Example:

SystemUnit IrSensor: Auto

Contents

Introduction

Web interface

System settings

Setting passwords

Appendices

System settings

Other manuals for Cisco TelePresence System Codec C-Series

Need help?

Do you have a question about the Cisco TelePresence System Codec C-Series and is the answer not in the manual?

General